250TPH Ilmenite Processing Wash Plant

Raw Material Feed Size: 0-400mm
Plant Location: Darwin, Australia
Main Equipment Lists: stone crusher, vibrating feeder + grizzly bar, rotary scrubber, high frequency vibrating screen, ball mill, shaking table, jig concentrator, magnetic separator, etc.

Project Introduction

Raw ore contains mud, 0-400mm size. The ilmenite processing plant usually goes through 4 stages: crushing, grinding, magnetic separation, and drying. The equipment used in the process plant includes a jaw crusher, cone crusher, ball mill, magnetic separator, spiral classifier, dryer, etc. The specific process is as follows:

Crushing:

raw ilmenite ore is first crushed by a jaw crusher, and then finely crushed by a cone crusher. After fine crushing, Ilmenite ore is sent to a circular vibrating screen for screening and classification.

Grinding:

the Pendulum Feeder delivers the qualified ilmenite particles from the silo to the belt conveyor. Then transported to the ball mill for grinding treatment for a period of time.

Magnetic separation:

the qualified ilmenite slurry enters the magnetic separators to be roughed and cleaned. In order to realize the separation of iron and other magnetic separation minerals from non-magnetic separation minerals.

Drying:

magnetic separation of concentrate pulp into the concentrator for initial concentration, and then into the dryer for drying dehydration. Finally, you can get a higher grade of concentrate mineral materials.